If you have any issues with Clean Room equipment, the slack channels associated with this space include: #general, ##general, #shop-3d-printing, and #shop-laser.
Orientation
The order of this document is to give some basic information of what will happen in the Clean Room during the training. This orientation assumes that they have gone through our general space orientation.
Do not operate any power equipment if you are under the influence of anything, in a hurry, are tired, or are not feeling well.
Inspect the equipment before using it.
Equipment
Thunder USA CO2 Laser Cutter (Thunder Nova 51/100)
Laser Overview
Orientation Notes
See
How to Use the Wiseley Fiber Laser
The Laser:
Open and create a design using Lightburn
Make sure you set the ventilation system to -10
Turn the Laser On using the keys
Set your passes, speed, q-pulse, power, frequency, and interval
Send the frame over to the machine
Put your metal material within the frame
Make sure the Laser is far enough away from the machine, using the button beside the machine
Close the door on the machine
Hit go on light burn
After it is finished, carefully get it out of the machine by its sides (Be careful, because the metal could be hot)
