Gas and Induction forge: Difference between revisions

Revision as of 21:17, 16 May 2026

General Information

The gas and induction forges are located inside the Metal Shop. When using any equipment in the metal shop, wear all proper safety equipment.

If you have any issues with Metal Shop equipment, the slack channels for this space include #general and #shop-metal.

Orientation

This orientation assumes you have already completed the general space orientation.

Do not operate any power equipment if you are under the influence of anything, in a hurry, tired, or not feeling well.
Inspect the equipment before each use.
Wear appropriate PPE: heat‑resistant gloves, safety glasses, closed‑toe leather shoes, and natural fiber clothing (cotton or wool). Avoid synthetic fabrics.

Equipment

Gas Forge – Housemade Apollo Forge

The Apollo Forge is a propane‑fired gas forge suitable for blacksmithing, knife making, and heat treating.

Outer dimensions: 11.5"W × 12.25"H × 19"D
Inner dimensions: 4.5"W × 6.5"H × 18"D (forge volume approx. 530 in³)
Maximum temperature: Up to 2,400 °F (1,315 °C) depending on propane pressure and burner tuning

For detailed startup, tuning, and shutdown procedures, see Gas Forge Operation.

Induction Forge – Coal Iron Works 15 kW Induction Forge

The induction forge uses electromagnetic fields to heat metal rapidly and efficiently. It is ideal for localized heating and is safer than a gas forge for many operations because there is no open flame.

Power: 15 kW, requires a dedicated 240 V, 60 A circuit
Heating: Small pieces reach forging temperature in seconds; depth of heating adjustable by coil design and power level

Setup notes:

The forge must be connected to a water‑cooling system (chiller or tap water) before operation – never run it dry.
Work pieces must fit within the induction coil opening.
Do not touch the coil or the workpiece during heating; use insulated tongs.

Recommendation: Most single users should stick with the induction heater. It has much faster setup, tuning, and cooldown.

@@ Line 11: / Line 11: @@
 * Do not operate any power equipment if you are under the influence of anything, in a hurry, tired, or not feeling well.
 * Inspect the equipment before each use.
-* Wear appropriate PPE: heat-resistant gloves, safety glasses, closed-toe leather shoes, and natural fiber clothing (cotton or wool). Avoid synthetic fabrics.
+* Wear appropriate PPE: heat‑resistant gloves, safety glasses, closed‑toe leather shoes, and natural fiber clothing (cotton or wool). Avoid synthetic fabrics.
 == Equipment ==
@@ Line 25: / Line 25: @@
 * '''Maximum temperature:''' Up to 2,400 °F (1,315 °C) depending on propane pressure and burner tuning
-'''Setup and operation notes:'''
+'''For detailed startup, tuning, and shutdown procedures, see [[Gas Forge Operation]].'''
-* 100 lb propane tanks are located behind the building and must be turned on '''in series'''. The pre‑regulator valve must be opened (moved down, inline with the gas line). Then open the post‑regulator valve.
-* The air supply/fan must be started '''before gas flow''' – this is critical. Air must be moving before any fuel enters the forge.
-* Use a small piece of lit newspaper inserted into the forge to ignite the gas. Make sure it is actually lit before opening the final valve (air flow can extinguish an unlit flame).
-* The flexible hose has a valve that must be opened just before the quick disconnect. Open this valve last – the forge should ignite immediately.
-'''For detailed startup, tuning, and cooldown procedures, see [[Gas Forge Operation]].'''
 === Induction Forge – Coal Iron Works 15 kW Induction Forge ===